Skip to content

Parallel port joypads

Linux parport joypad driver

RetroArch supports parallel port joypads on Linux via the "parport" joypad driver. It uses an extended version of the Linux Multisystem 2-button joystick protocol.

Function Pin Register Bit Active
Up 2 Data 0 Low
Down 3 Data 1 Low
Left 4 Data 2 Low
Right 5 Data 3 Low
A 6 Data 4 Low
B 7 Data 5 Low
Start 8 Data 6 Low
Select 9 Data 7 Low
Menu toggle 10 Status 6 Low
X 11 Status 7 Low*
Y 12 Status 5 Low
L1 13 Status 4 Low
R1 15 Status 3 Low

(*) Pin is hardware inverted, but RetroArch inverts it back again so the same pullup scheme may be used for all pins. Pin 1 is set high so it can be used for pullups.

RetroArch does not perform debouncing, and so long as the button settling time is less than the frame time no bouncing will be observed. This replicates the latching behavior common in old games consoles. For optimum latency and jitter a high performance debouncing routine should be implemented in the controller hardware.

Parallel port hardware does not provide a way to detect non-connected pins. To avoid rendering the menu usable with spurious button presses, RetroArch checks each pin on startup and assumes any active pin is not connected. Avoid holding joypad buttons while starting RetroArch or those buttons will be disabled.